Can I Install Sign in PaperWise

Can I Install Sign in PaperWise

hi I'm Lynn McCormack with sign partners you may have come across this video because you've taken advantage of our online special for 10 two-sided chloroplast science complete mistakes or you may have already witnessed your own frustration trying to stab steaks onto signs so what I'd like to show you is there's a couple of kinds of states that you can use and the core class signs that you'll get have what's known as flukes in them now not flutes like a musical instrument but a fluke like you accidentally did something right okay and these are only four millimeters thick and the wireframe steaks that you get also have approximately four millimeter wires in them now if you look closely you'll see that these are not parallel and if they don't go into the sign straight you may wind up with a sign that looks something like this crunched up where they bent the flutes or maybe even boat in the middle better shot okay so we'll try to prevent that and reduce your frustration with a couple of simple tips now as you can see since we do a lot of this I have my own pattern that I taped to the table but you don't have to go to that much trouble I'll set this aside and show you that you can simply take some tape and lay down on the table a hard surface and Mark it and if you do it that way you can use that instead of marking your table up at home so if you'll come around here we'll take a look at the best way to do that she'll edit this part out I guess right now that we've marked our tape I'll also mention to you I'll also mention to you that when you get ready to mark your tape you can place the edge of the sign on the end of the tape and then find an equal distance from both ends for where your Y frame stake will fit so if you lay your y frame stake down first and measure from one side I have about seven and a quarter inches here and then I measure from the other side and I have about six and three quarters here so if I move it over just a little bit I'll have seven here now and about seven over here that way if you mark your spot the same on your tape that way every sign that you lay down will have the stakes in about the middle once you lay your sign down where you want it you'll want to have something like a marking pencil now this is a wax grease pencil that we use if you line a fluke up with the mark that you've made already and lay the base where the crossbar is down on one side then you can mark the correct flute and Mark this flute first lay it down...