Descubre Software Solar Solo Para Soluciones Hightech

Solo solar software for HighTech

[Music] welcome to the green energy options guide to resetting and pairing your solo display this guide can help you if your solo regularly or always shows a flashing lightning bolt symbol like in this example or if the symbol simply does not show you at all to start we need to set a display and transmitter next to each other the display should be powered by mains adapter only and the transmitter by batteries if you already have the transmitter set up by your meter you can remove the sensor cable and bring the transmitters to this flame so that you can work with them together firstly we need to remove one battery from the transmitter open the transmitter case like this and take out one battery and place to the side next we need to reset the network on the display this process will force a change of channel that results most interference based problems ensuring the display is turned on and on the main screen locate the pair button on the back and hold it in for six to eight seconds until the message net left appears release the pair button and press the middle button on the front of the display with one short press the display will now show a version screen and end on the main screen showing zeros you we have now reset the display and change the channel it now needs to be paired to the transmitter to do this press the power button on the back of the display with one short press the screen will change to pairing with the channel number at the top and the speedo counting round the display is now looking for the transmitter we now need to hold down a small button on the transmitter while replacing the battery it is important to keep the button held in before the battery goes in and for a few seconds afterwards you will notice a small green light flash next to the button as you put the battery in the two devices will now pair the display will confirm a successful pairing with the following screen returned to the main screen by pressing the middle button on the display after a short while the lightning bolt symbol on the display will light up and stay solid that is it you can now return the transmitter with the LED sensor to the meter you should see your readings coming through as soon as the LED sensor detects a pulse from the meter you if you notice the lightning box symbol flashing it is possible the Soto has chosen an unsuitable channel and you will need to repeat the process from the beginning