Add Boat Slip Lease Agreement Electronically Signed with airSlate SignNow

Add Boat Slip Lease Agreement electronically signed

hello and welcome to ABY C TV today we're going to install an ELC eye it's an equipment leakage circuit interrupter it's kind of like a bathroom GFCI but for a whole boat protection what you can see here is we now have exposed our Shore power in and our load side of our AC electrical system on our project boat you'll see at this point we have our black our hot our white our neutral and agreeing our ground and we have the corresponding colors on the load side as well we're going to walk through crimping on rink terminals on both sides and then putting the load side through the toroidal transformer on our LCI you'll see it tells us exactly what to do here we put our neutral and our hot through here and we'll explain how that works in a bit okay so at this point we've already talked about the fact that this is our incoming so this is our line we're going to heat shrink and buck connect each one of these conductors so put it in give it a twist fit snugly then we will go ahead with our crimping tool give ourselves good crap and we're going to repeat that for every other conductor we have coming in on the boat I like to use the heat shrink with the the goo inside it's kind of glue that is activated by heat so you'll see when it finally actually takes and shrinks up to the size we need there's a little bit of glue that comes out on both ends just think it adds to a little more quality connector of course when you're doing this make sure you're not in the gasoline engine space just about happens to be a diesel but we are well ventilated and not concerned while we're taking a look at our load side and we have our stripped wires ready to go I did not crimp them yet because I want to be able to fit them through what we call a toroid on the back of the ELC I the way an ELC eye works is it senses the differentiation and current between the hot and the neutral in an AC circuit the exact same amount should be going up or down the black wire and back the return wire are neutral if there is a differentiation between the two the ELC will sense the difference and expect that it is going somewhere else generally down the ground wire it does not sense the ground wire it senses the difference between these two conductors and that's what the toroid transformers 4 blue sees in their instruction manual recommends that we twist the black and the white before we insert into the toroid so I'm gonna go ahead and do that now we've given ourselves a generous amount of cable here we are now twisted and I'm going to insert through this side and retrieve it...