Assemble Assign Signatory with airSlate SignNow

Assemble fax autograph

assembly of Stressless signature based models your Stressless signature model chairs should have been received in two boxes one box contains the arms back cushions and ottoman cushion and the other contains the chair yoke the signature base the ottoman base and hardware make sure all parts are accounted for before beginning the assembly to order replacement parts please email office at Ekron Escom unzip the back cushion exposing the connecting joint at the bottom of the seat cushion marry the connecting joints on one side of the back cushion with the connecting joint on the seat cushion and fasten with the bolt do the same on the opposite side of the cushion set and secure close the zipper with a cushion set facing down thread the signature base around the glide knobs on the seat cushion note this is a very tight fit the easiest technique is to ensure that the first glide wheel is positioned in the front corner of the arm bracket and then roll the arm bracket around the remaining glide wheel towards the opposite corner as shown secure the glide wheels check to ensure that the are secured to the arm bracket before attaching the back cushion the locking rings may already be connected to the arm bracket as seen here there is an additional plastic cover that protects the leather when connecting the seat cushion and is designed to pop off during assembly pull the seat upwards toward the backrest coupling bolts and secure the backrest over the pins on the arm assembly rotate the locking ring so that the long part of the ring faces forward with the chair cushion facing down attach the signature base using the supplied screws into the pre-drilled holes on the bottom of the yoke due to the position of the pre-drilled holes the base can only be attached one way secure the arm pads to the base first slide the three clips on the arm cushion around the flat hooks on the arm bracket push the dowel on the arm pad into the space provided on the arm bracket until you hear it click into place secure the arms with screws the long screw in the back of the arm bracket the short in front to order replacement parts please email office at eccrine s com to mount the ottoman cushion to the Ottoman base start with the cushion on the floor bottom facing up position the dowels and the holes on the base secure with locking plates you