Carbon Copy eSign Attempt with airSlate SignNow

Carbon copy esign conclusion

hi in this video I want to show you how I constructed this hood which is a hood over a mounting base for a electronic device and it's closing hood we can look at it from the bottom it's got some mounting holes it's got an insight structure 2 millimeter walls and so on so I want to show you how I constructed this from first having the mounting plate as such I want to show you how I did it so before we start let's delete what we have in the comments to the video or in the description you can find a download location if you want to do this step by step where you can find this particular file without the hood so normally we would say ok we create a new body we create shape binder and then we start to construct based on the shape binder but this time I want to show you a different approach which in some cases may even be the easier approach and it also shows you a couple of things around relatively new function in free kit called a carbon copy and at the end of the video I want to show you some other things that you can do with this column copy function also so let's start and begin the construction off the base is fairly straight ahead and let us switch everything up first and also let us switch off the sketches as they have evolved during the construction of this simple piece so first there was a block and in that block I created some insects another set of insets holes holes to hold some metal sheet Indian sets host for the hex nuts that are at the lower side and a couple of pets to keep the whole structure a little bit above ground and so on but we don't need everything what we need is the things which are visible on the upper side and that's the main sketch that's the insects and probably these things and we need the mounting holes because these are meant to be screwed through the body let us see the stuff as it is in this particular step of construction we have these holes and we have the insects so we start by switching to part designs I've done this with a relatively new version at the time of during the video fifty nine nine eight that's one of the last versions that came out before we soon can expect the release version okay so create a new body for those who are still unclear a body in free cat part design should always be a piece that is one piece in its in itself so this body has got its own origins we start by creating a new sketch in the second body we put it on the XY plane in the model tree we switch off pocket 0:06 and what we actually want is we...