Carbon Copy Signed Electronically EIN with airSlate SignNow

Carbon copy esign annex

okay two part forms as you can see with the ream there is arrows on one edge that edge needs to be facing up in the machine so that you're printing on the side that's facing up and then you also want to make sure that that side is the side that gets glued so if i take this ream or at least a part of it and put it in the bypass tray there's the arrows needs to be facing towards the top so there's the arrows and then the arrow needs to be pointing up because that's the side the ink goes on and as far as the settings on the machine uh plain white is fine so go ahead and hit confirm so you want to make sure when you're doing this you go ahead and put the original face down top to the top you want to choose tray 5 because that's where we put the paper you want to make sure it's definitely black and then sometimes depending on the file i would darken it maybe one uh maybe two you can do one just to test it and under under output format you just want to go face down as an option and then you need to remember there's two parts to this set of forms sometimes there's three parts sometimes there's four parts so you want to make sure like if you're doing even one set you don't just do one you actually need to do two because there's two sheets of paper so i'm gonna go ahead and run this so what happens is they come face down so when you do a bunch of them you got the white and the yellow otherwise if you didn't do face down then the white would come out like this and then the yellow would come out like this and then you'd have to collate them all and it would be a hassle so now if you print them on the right side take a pen and if you were to write on this in any way the next sheet will show up just like that so you do want to test to make sure um another good way to do it is if you feel this paper it's smooth on the side that's unprintable has a little bit of toothiness to it a little bit of texture to it so that's another way to tell but if you just follow the arrows everything will be fine um just remember that the multi-part forms are charged by the set so you just want to make sure that um you know you're if this is a set you're doing you know that's just one set right there even though it's two sheets um and then the gluing i've just stacked them over here now i'm gonna figure out a better way of doing this but i just put a catalog on top to get it...