Cc Byline Proof with airSlate SignNow

Cc byline proof

[Music] cc bend it and cc bender can both be found under the distort category and you might have guessed this already but they both will bend your layer in interesting and unique ways and if i open that up and apply it to my layer i have this both as an illustrator footage file as well as a shape layer and i'll actually apply it to both so we can see how this effect handles vector versus raster let's start with the illustrator raster version of my logo first immediately my layer is cropped and this can be one of the most confusing parts of this effect what this effect actually lets us do is bend our layer in a very smooth way but it's generating a distortion mesh which crops your layer based on the start and end position values so if i were to increase the start position's y value to bring it down towards the base of my layer that distortion mesh grows you can kind of see the bounds of it here it's kind of a rectangle and to make this really clear i'm going to add our trusty grid effect just before cc bend it and make my squares just a little bit smaller so we can see this is actually just cropping off our image to make this rectangle visible and if i move the endpoint's y position up then we can get it to at least show the entire vertical height of my layer i'll turn that grid off and we can see that's containing the entire logo but if i had anything out on the sides here of my layer then it's still going to be cropped off the solution to that problem is to just keep extending this end point upwards off the top of your layer until everything that you need to see is visible but once it is all visible you can start using the bend property to really distort it now this is constrained to the bounds of my layer so if i need to bend further than this then i'm going to use the grow bounds effect before cc bend it which will allow me to just extend the bounds of my layer further out there are lots of little workarounds like this for this effect so just hang on we're going to get through all of them i'll get rid of that grid effect and let's take a look at the controls we've already seen that the bend value is what controls how bent our layer actually is the start and end points determine where that bending takes place but what about this render pre-start value by default it's set to bend which is giving us this look but if we change it to say static nothing changes until i grab the start point and bring it up now this is cropping in on my layer so i'm going to move the end point out...