Create Initials Time with airSlate SignNow

Create initials time

this is the isobar one-timer control valve we know that it's a timer control valve because we had a one through twelve pin setting here and what we'll talk about today is how to set up the control valve after initial install the very first thing that you should do is to change the time of day and to do that you just push this black button in and you move the top gear here and that'll show you down here what time it is and you want that time to be the current time that it is right now the next thing you'd want to do is to set your regeneration schedule by these pins each pin represents one day in each day the style will move one notch to the left in your install manual they'll be a chart that will show how hard the water is versus how many people and that will tell you how many pins you need to pull out on this time so let's say it tells you you need to pull out four pins to do that you just pull out every third pin in this case since it's the 1 through 12 dial by pulling on every third pin this will make it regenerate every third day so each day it's going to move one notch to the left and when the pin that's pulled out is alignment with the red arrow it will go through a regeneration and to simulate a regeneration all you would have to do is to turn this down clockwise and as you can see through the little window here it'll tell you exactly where you're at in the regeneration each regeneration is is about two hours it's factory preset at 2 a.m. if 2 a.m. is a bad time for you and you think you might be using water at that time all you have to do is change the time of day it's a full the clock that it's a different time that's basically all I have to do always refer to your install manual and you can always visit our website water soft inc.com