Forward Mark Link with airSlate SignNow

Forward mark link

Hi, my name is **** and an application engineer at maximum degraded. Today I'm going to talk about maximum Gm is a serializer and days later in this video, I'm going to discuss how to set up forward, generally in z missiles or dispute. Or this can be done with any of our chipset. But today I'm going to talk about max nine to five and Max 92768. Before we start, we should know what is there inside this ChIP-Seq. Now have a look on a block diagram showing at your screen a GM muscle one chip set consist of a two-channel. The first one is forward radio channel, which goes from serializer to deserialize it. And other one is reverse control channel. Now we're specifically going to be focusing on forward radiation. To work your forward mutagenic perfectly fine. You should have two things. The first one as well, pixel clock on the serializer, and the next one is matching configuration as historicity. If you're getting a valid pixel clock, then you could see a Link-Local lady on the de-serialize our site. Link locks tell you that PLL is locked and pixel clock is recovered with current Bitcoin. If you are not getting a link, look, make sure that BtoB Lewis and HIV resistors are matched on both the side of the Saudis pair. If you are getting a valid pixel clock, then in order to make your data going out same as data going in. Blue are the registers which need to be matched on both the side of the Saudi spare. Make sure that you're all other registers are set to their default positions. Let's have a look on our demos at the block diagram shown on the screen. And I've use max 96 zone of five qx e. We get to program onboard oscillator to generate 25 megahertz a pixel clock for max nine to sun five. You're going to of course use any plugged in it are in the range of 25 to 50 megahertz said earlier, we will in the market to perform this setup to verify that the forwards and a link is properly configured. I've sold a LED on the doping of the de-serialize the site. On changing Dean pin high and low from the serializer, the corresponding, the open should change. Let jumps to the setup and see what's going on if we change Dean pin high and low on the site. So here is a demo setup. This board is max 96 seminal five, which is generating a backlog for max 9275. On the other side, we have Max 9276 a with the LED on the outs haven't been. Both of these are despair or power to the USB. Y max 96 zone of five is power to the Ellwood adapter. Make sure that to change jumper GU PL1 and jump but be a little too high positions while the rest of the jumper should be set to their default...