Integrate Signed Adjustment with airSlate SignNow

Integrate signed adjustment

first press the ICA to button at the bottom of the home screen combine settings will be shown on the top left to use the ICA option you will press the optimize performance button once you are on the next page you can select which options you are having issues with it will then ask you a series of questions and where the issues are occurring it will then give you a multitude of options to adjust the combine automatically or manually to fix the issue you are seeing also in the ICA 2 page is the Harvard smart option which is a setting for machines with pair drive transmissions to maintain a consistent crap flow based off the conditions of the machine it will adjust the ground speed based off the operator selected settings next is the active terrain adjustment which adjusts the cleaning fan chaffeur and sieve settings in the combine based off of a percentage of grade that the combine is on or simply if the combine is heading up or downhill in the field the combine will make adjustments based off the severity of that hill if an exclamation point is appearing that a calibration has not been completed yet in this case there is an issue with the active terrain system next is the auto maintain feature this feature once set to the operator's preference will maintain grain or straw quality based off the priorities that are set once the straw or grain quality is set to your liking you will press the set performance target button which will tell the system that this is what you would like it to maintain it will then learn what you have set the auto maintain will adjust the combine settings in order to achieve that target as conditions change the status box will alert you to any issues or if the system is ok the priorities are very important part of the auto maintained operator needs to set the wanted priorities in order to achieve optimal performance to adjust them press on the priorities box select the ones you wish to move number one being a top priority and number four being the lower prior lowest priority once they are tier likings press the ok button to make sensitivity adjustments for the auto maintain and the act of terrain adjust you would click next to the master on/off buttons and it will take you into the advanced settings once these are adjusted to your likings you can the X to close out of that in the auto maintain advanced settings it was recommended that the response aggressiveness is set to increased the grain loss is set to increased the broken grain usually stays at default unless in dry moisture conditions then it is set to maximum the foreign material settings is recommended at the increased setting