Merge Initials Adjustment with airSlate SignNow

Merge initials adjustment

hello everyone i'm mark with the kenfeld group today we're going to go over the go harvest app and how to get your s760 set up ready to run soybeans so when you go into the app you're going to actually go in and tell it what combine you have this app also works for other models of combines which today we're using this one so it's going to take you and show you what you need to change on the outside of the combine and inside the combine to get it ready for soybeans so over here on the left side of the combine we're going to want to make sure our drum is in the correct position currently this drum is in the up position for small grains and soybeans we'd want it in the down position so make sure you get that adjusted as well as make sure your rotor is in the correct range so that when you fire it up and it does this auto adjust feature it'll get itself in the right rpm the next spot we're going to go to is our chopper it wants you to set the knife so you want to make sure your knives are slid in fully if you want a lot of chopped material if you slide them halfway there is a gain of horsepower from there as well as a little better spread because the pieces will be a little bit larger and easier to throw the other thing you want to make sure is that your chopper is in the right speed so for soybeans you're going to want it into high to get as wide a spread pattern as you can to match your header with as we go around the machine we're going to come over here we'll make sure that our crop divider is in its proper position currently it is up in small grains so the chopper's not blocked any that way it'll get as much material in there as possible you also want to make sure your elevator doors are all shut before you harvest as we come around here on the right side we're going to make sure that your feet accelerator is in the proper speed depending on what you're wanting to do if you're doing seed beans you're going to want to stay in low range if you're running beans that are a lot of green stem and are tough then you might want to suggest going into high range with it it's simple un loosen the belt pull open your shield and change it according to the diagram to get the range that you want and back on the feeder house then we want to make sure we put it in our our large sprocket on the feeder house to run the chain fast for small grains as well as change your drum position over here as well and that's what's needed on the outside of...