Move eSign Copy with airSlate SignNow

Move esign copy

this video will cover Libra designs copy move and rotate sketch features there are many different ways to move copy or wrote a sketch figures in a Libra design here are a few examples nodes can be manually dragged to new locations in the same sketch clicking and dragging on a node will allow you to move the note or sketch figure to a new location that is approximately where you need it when you are in select mode if the sketch is not - mentioned or constrained click and drag on a node and you will see the figures move to a new location if the figures are constrained or dimension you may not be able to move them to a new location if doing so will interfere with either the constraints or dimensions if that's the case those dimensions or constraints will need to be removed before the move command will work here's a quick and easy way to make multiple copies of an item and place these copies wherever you need them well in select mode right-click on a sketch item you wish to make a copy of and select copy from the pop-up menu with the left mouse button now right-click once again anywhere in your workspace but this time select paste Stamper from the pop-up menu you should see a copy of the item you selected hovering near the mouse cursor now simply left-click wherever you wish to place a copy to end the paste Stamper process press the right mouse button once again to return to select mode by the way now be a good time to take a look at the commands available on the pop-up mouse menu many of the commands you will frequently need are only a mouse click away on this menu to move and/or copy multiple item simultaneously in the same sketch sketch tools box on the 2d ribbon bar while in sketch mode select move located here then select the figures you opt move selections can be made in different ways the first way is to select multiple items at once and the other way is to select individual items to form a group of items these methods can be used independently of each other or in combination with each other in both cases when the figures are selected they will change colors so you can see which items are selected to select multiple item simultaneously window around the figures click and drag the mouse from one corner of the design to the opposite corner of the design when creating this window if you click from left to right only the figures that are located entirely within the window will be selected if an item is only partially within the windowing area it will not be selected if you have figure selected that you do not need hold the shift key down and select the figures this will remove only the ones you don't wish to be in...