Scan Corroborator EIN with airSlate SignNow

Scan renter EIN

[Music] hi i'm gabriel account manager in 3d and today we are going to scan with the iscan hx in this case we are going to use the laser mode and the structural light mode for this special case we are going to put some markers in the part so we are going to use magnetic markers so let's get started after sticking the magnetic markers on the roof pillars and the partition we start the x-can software for inscan hx we will create a new workspace and choose the laser scan mode marker alignment and then we can adjust the brightness in the preview [Music] we are starting in the partition so we are adjusting the brightness settings to black now checking if we have the right distance to the object which is displayed by the green light on the scanner and in the software this is fine so we start scanning [Music] as we can see the seven cross blue laser lines track the markers in order to capture the part it's important to always pay attention if the tracking is working correctly and the markets are recognized if not maybe more markers are necessary because the scanner must be able to see at least four markers in the scan field at any time if you still have trouble with the tracking an easy solution would be also to calibrate your scanner properly [Music] as you can see the first scan is completed we are not going to scan the whole bank in one project that will be too difficult because of the site and the layout to have a more enjoyable scanning process we will create multiple projects and thus avoiding mistakes this gives us also the opportunity to utilize both projection methods of the einscan hx so each part of the bank will be a new scan later we are going on to align them together into one this gives us also more flexibility if at some point for example we only need one specific part of the vehicle which makes things easier to work with it is practical to start scanning on an already captured part from the old project in order to have some common points to align between the all and the new one same process point the scanner to the surface check for the right distance and press start the first brightness settings were suggested for the black surface so when moving over the white surface of the pillars on the roof the image is way too bright luckily we can chance it while scanning with the dedicated buttons on the scanner you can also change the zoom with the other two buttons to your liking with no need to do it on the [Music] computer [Music] so [Music] after obtaining enough data from this second project we proceed to generate the point cloud and then align the different projects in this case we will align them thanks to the autoline feature...