Scan Receiver Attachment with airSlate SignNow

Scan receiver attachment

hello and welcome back to the next episode of the dwrl 3d receiver from Sony and today we talk about the scan functions as always before we start if you liked the video thumbs up if you don't like the video thumbs down if you have any idea what I can do better or what you like to see write it down in the comment field ok the D tablet RSO 3d from Sony has three scan functions a clear channel scan an active channel scan and an automatic setup scan let's start with the Clear Channel scan I have set up channel 1 where's the piece or the body pack here and what you do is you press the menu button one time and then you had Eric's number 1 and you see I have set up the group D 7 in TV channel 24 frequency 49 which is 501 to 5 megahertz scroll down in the menu until the point clear channel scan press the set button for for 2 seconds and then it will start the scan I have choosen group D 7 years so the receiver will only scan frequencies in the group D 7 which makes the scan much shorter and it is always clear that between the frequencies the correct channel spacing is used now the skin is ready and the receiver shows you a bunch of frequencies and it starts with the first frequency and the lowest noise in DB microworld which is of course 0 DB because we have no antenna attached here if you if you use the plus pack you can go to the next frequency and it shows you the list of frequencies ordered by the noise so it goes up to 20 dB Ruka world which is the highest noise only except as a free channel if you have further freaking through you like to use press the set button it asks you if you like to sync group and channel - the Teague's you say yes and job done that's all that's the easiest way you can do this for channel number two and then you're ready to go next game function is the active channel scan function the receiver scans the group and channel you've chosen and it shows you if there is a Sony transmitter available and it shows you some data about the transmitter and then you can adapt this transmitter to the channel where you start the channel scan if you press the plus button one time here on the active channel scan and you simply stop the scan by pressing the set button for two seconds to say yes and it starts now the receiver scans the frequency in the group I have chosen and it shows me if there is another transmitter available the transmitter the receiver found of course is the p30 here we can press set to assign these transmitter to channel number one of the receiver the short...