Assemble Assign Mark with airSlate SignNow

Assemble fill mark

before beginning reassembly of a Ruger Mark 3 pistol make sure that the magazine and receiver are completely unloaded for reassembly the safety must be in the off or fire position place the hammer in the horizontal or cocked position the hammer is visible by looking down on the grip frame and is the rectangular object inside the grip frame and near the rear if you cannot place the hammer in the horizontal position it is most likely because the hammer strut is trapped behind the cross pin if this occurs lift the hammer to free the hammer strut from behind the cross pin point the gun up and then move the hammer into the horizontal position if the hammer has been rotated too far forward it also may not be possible to rotate it backwards if this occurs fully insert the empty magazine and pull the trigger once the hammer is horizontal remove the empty magazine before placing the barrel receiver assembly onto the frame make sure that the loaded chamber indicator pin is in its place in the receiver place the barrel receiver assembly on top of the frame so that the lug engages the square front recess push the barrel receiver assembly rearward until it stops if the barrel receiver assembly is properly fit the rear end of the receiver will slightly overhang the rear end of the grip frame if proper alignment of the barrel receiver assembly and grip frame cannot be achieved by hand place the pistol on a padded bench muzzle down and lightly strike the rear of the grip frame below the receiver with a plastic or wooden mallet fully insert the empty magazine into the mark three point the muzzle up in a safe direction and pull the trigger gravity should cause the hammer to return to the [ __ ] position if not reach in to the rear of the receiver and push the hammer back down flat into the horizontal position when the hammer is in this position remove the empty magazine verify that the slide release lever is fully downward the bolt cannot be reinserted if the lever is up before sliding the bolt into the receiver be certain that the firing pin stop is in the bolt without this pin the first time the trigger is pulled on an assembled pistol the firing pin will fly forward so far as to irreparably dent the rear of the chamber of the big making in the pistol useless now slide the bolt with a recoil spring upward fully forward into the receiver insert the empty magazine point the muzzle toward the ground in a safe direction and pull the trigger the hammer should fall to its full forward position if it does not retract the bolt partially and manipulate the hammer through the slot in the rear of the frame until the hammer is in its full forward position remove the empty magazine point the muzzle towards the ground with...